Windows installation encountered an unexpected error, 0xE0000100
If you're encountering the fault bulletin Windows installation encountered an unexpected fault on your reckoner while installing Windows ten, you tin can endeavour the solutions nosotros will present in this postal service to assist yous resolve the consequence.
When you lot run across this issue. you'll receive the post-obit full error message-
Windows installation encountered an unexpected error. Verify that the installation sources are attainable, and restart the installation.
Error code: 0xE0000100.
The error code can also appear during Windows Update.
During installation, this fault tin can exist caused by diverse problems. It could be acquired if there is a problem with the deejay partition, with the Installation media – and fifty-fifty if there is low or damaged RAM, corrupted registry files, or incorrect hardware configuration.
Windows installation encountered an unexpected fault
If you're faced with this error code 0xE0000100 during installation or during Windows Update, you can try our recommended solutions below and run into if that helps to resolve the upshot.
- Clean the partition
- Run CHKDSK Utility
- Run the Hardware Troubleshooter
- Check RAM
- Modify the LoadAppInit_DLLs registry key
Let's accept a look at the description of the procedure involved concerning each of the listed solutions.
1] Clean the partition
You can use the built-in diskpart tool to clean your partitions.
You may boot to the Avant-garde Startup Options screen or use the installation media, boot to the Repair your calculator screen.
Here, access the Command Prompt and execute the following commands one after the other:
diskpart list disk select disk 0 make clean
Restart and see if you can install information technology.
3] Run CHKDSK Utility
A decadent hard drive or bad sectors on the drive tin can also lead to the issue. In this case, yous tin can run CHKDSK (cheque disk) utility to try to fix the disk corruption due to bad sectors.
Run the following control:
chkdsk c: /f
On restart check, if it helped.
1] Run the Hardware Troubleshooter
This solution entails that you run the inbuilt Hardware Troubleshooter and see if the error is resolved.
ii] Bank check RAM
Plough off the arrangement and supercede the RAM with another RAM. You may also swap RAM slots and and then boot the organization. Check if the error still persists. Swapping of RAM is required when there is concrete damage to RAM connectors or hardware.
Too, run a memory diagnostic examination on your RAM using Memtest86+ to fix the issue.
three] Modify the LoadAppInit_DLLs registry cardinal
Corrupt registry files lead to serious problems in the arrangement including this error.
Do the post-obit:
Since this is a registry operation, it is recommended that y'all support the registry or create a organisation restore point as necessary precautionary measures. Once done, you tin can proceed every bit follows:
- Press Windows key + R to invoke the Run dialog.
- In the Run dialog box, typeregedit and hit Enter to open Registry Editor.
- Navigate or jump to the registry key path below:
Computer\HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Windows NT\CurrentVersion\Windows
- At the location, on the right-paw side, double-click on the LoadAppInit_DLLs registry central to edit its properties.
- In the properties window, set the Value data to 0.
- ClickOK to save changes.
- You can now shut the Registry Editor window.
- Reboot your computer to allow the changes take effect.
Windows Update Error Code 0xE0000100
The error code can also announced when Windows Update fails. In this case, endeavour the following:
- Run SFC scan
- Run Windows Update Troubleshooter
- Plow off DEP.
Promise something here helps you.
Source: https://www.thewindowsclub.com/windows-installation-encountered-an-unexpected-error-0xe0000100
Posted by: kovacsancence.blogspot.com
0 Response to "Windows installation encountered an unexpected error, 0xE0000100"
Post a Comment